Radial Pro 48 Direct Box
Customer Care -

Radial Pro 48 Direct Box

Radial Pro 48 Direct Box

Radial Pro 48 Direct Box

  • Vendor: Bliaudio-skr
  • Shipping Origins: Jakarta Utara, DKI Jakarta
  • Product Code: Radial Pro 48
  • Availability: In Stock
  • Rp 2,200,000

1 Year Distributor Warranty

Active Direct Box

* High performance active direct box

* Increased dynamic range and headroom

* 48V phantom powered with switching supply

* Ideal for acoustic guitar and bass

The Radial Pro48 is a compact high-performance 48V phantom powered active direct box designed specifically for todays high output instruments.

The Pro48's innovative internal switching power supply significantly increases headroom producing less distortion while yielding a smooth, linear response that extends from 20Hz to well above 40kHz. This results in natural, uncolored signal that is as good or better than DI boxes costing several times more. The superior performance makes the Pro48 an ideal candidate for use with battery powered active basses and acoustic guitars that tend to overload other direct boxes.

The compact Pro48 is built road-ready with 14 gauge steel throughout. A unique book-end™ design creates a protective zones around the switches and connectors while the internal I-beam construction assures outside stress will not torque the PC board and deteriorate solder connections. A full bottom no-slip pads adds mechanical isolation and electrical insulation to further extend the Pro48's lifespan.

Exceptional sonic performance, great natural tone and an affordable price tag! The Radial Pro48 truly represents a breakthrough in value.

Specifications are subject to change without notice.
Audio circuit type:Proprietary analog circuit with low-noise op-amp
Frequency response:20Hz ~ 20kHz (± 1.5 dB)
Signal to noise ratio: 
Dynamic range:99dB
Noise floor:-82dB below 0dBu
Equivalent input noise:-86dBu
Maximum input:+9dBu
Phase deviation:+28º at 20Hz | +1º at 1kHz | -2º at 20kHz
Total harmonic distortion:0.001% @ 0 dBu
Inter-modulation distortion:0.002% @ 0 dBu
Input impedance:220kΩ - ¼" input
Output impedance:600Ω - XLR output
Input pad:-15dB
Ground lift:Disconnects pin-1 at XLR output
XLR configuration:AES standard (pin-2 hot)
Power:48V phantom - proprietary digital switching
Construction:14 gauge steel chassis and outer shell
Finish:Durable powder coat
Size: (W x H x D)Size: 2.75" x 4.25" x 1.75" (70 x 108 x 44mm)
Weight:1.2 lb (544 g)
FCC approval:Complies with section 15 of the FCC Rules
Conditions:For use in dry locations only between 5°C and 40°C

Write a review

Note: HTML is not translated!
    Bad           Good